Fluid

Fluid is a special block that can act as fluid. It will spread across the world.

NeoForge 26.1.2NeoForge 1.21.1

Step-by-step guide: how to make fluid →

Fields you fill in

Before replacing block

This procedure is executed before the fluid replaces a block other than air (for example tall grass).

Bucket texture

This optional property will change the texture of the bucket in the inventory, replacing the autogenerated one.

Can sources multiply

If this option is enabled, fluid sources can create more sources, similar to water. This makes it possible to have an

infinite source.

Density

Set a density value in kg/m3 units.

Drip particle

This parameter controls the particle that the fluid will generate when dripping from a block.

Bucket empty sound

This parameter controls which sound will be played when the bucket is emptied. If no sound is selected, the default bucket

sound will be played.

Enable bucket

This parameter controls whether this fluid can be put in a bucket.

Flow condition

This condition determines if the fluid can spread from a certain position.

Keep in mind that this is also affected by other properties (nearby slopes, solid blocks etc.).

Flow rate

This parameter determines how many ticks it takes for the fluid to spread to another block. The higher this value is, the

slower the fluid will move.

The default values are 5 for water, 30 for lava in the Overworld and 10 for lava in the Nether.

Flow strength

This parameter determines how much the fluid pushes entities when it's flowing. With negative values it will pull entities

instead of pushing them away.

Fog color override

This parameter determines the color of the fluid fog.

Leave unspecified to use default fluid color handling.

Fog end distance

This parameter determines the distance from the camera at which the fog ends.

Fog closer to the camera appears more dense.

Fog start distance

This parameter determines the distance from the camera at which the fog starts.

Has fog

If this option is enabled, the fluid will display a fog while the player is submerged.

Level decrease per block

This parameter determines how much the level of this fluid decreases for every block it spreads to. With higher values,

the fluid will cover a smaller area.

This value is 1 for water and lava in the Nether, 2 for lava in the Overworld.

Luminosity

Set the light value of your fluid. Setting the value to 0 will disable the light.

Render overlay texture

If a texture is selected, it will be displayed as an overlay while the player is submerged.

Slope find distance

This parameter determines how far away a slope can be to affect the spreading of this fluid. Instead of spreading evenly,

the fluid will try to reach the slope. With lower values, the fluid will usually cover larger areas if the ground is uneven.

Spawn drip particles

If this option is enabled, the fluid will generate particles when it's above a solid block and there's air below it.

Temperature

This is the temperature of your fluid, measured in Kelvin. The higher the value, the hotter your fluid will be.

The default value is 300K, which is around room temperature.

Tint type

This option applies a tint to the fluid based on biome colors, similar to grass, leaves, and water.

For best results, the fluid should use a grayscale texture.

The tint type also affects the autogenerated texture of the bucket.

Fluid type

Controls some of the fluid parameters:

  • Color on the map
  • Fall distance modifier
  • Whether the fluid can extinguish fires (water only)
  • Whether the fluid supports boating (water only)
  • Whether the fluid can hydrate crops (water only)
  • Whether the fluid causes drowning (water only)
  • Whether swimming is possible (water only)
Viscosity

The viscosity is how difficult it is to walk in the fluid.