
Biome is a specific area with defined world generation, color, weather and fauna.
Step-by-step guide: how to make biome →
This parameter is a used to determine whether the replacement is attempted, similar to a percentage.
This parameter is a scaling value used to alter the frequency of replacement attempts. A lower
frequency will mean a bigger contiguous biome area that occurs less often. A higher frequency will mean
smaller contiguous biome areas that occur more often.
This parameter specifies a list of biomes that this biome will attempt to partially replace during
world generation. Note that vanilla biomes within the specified list are not completely overridden, and
will still generate alongside this biome.
Biome tags are identifiers used to categorize and group biomes. They can influence a wide range of game
behaviors, including how structures generate within a biome, what world generation features such as
vegetation, terrain and decorations appear, which creatures and mobs are allowed to spawn, or what
properties they have. Multiple tags can be applied to a single biome, and many systems in the game
reference these tags to determine what content is appropriate for a given biome.
This parameter controls the block on the top layer of the biome.
Generally, vanilla or custom grass is used here for most biomes.
Avoid using complex blocks such as:
If you use such blocks, the worldgen will be slow and the loaded world may lag severely.
This parameter controls the block right below the ground block layer.
Generally, vanilla or custom dirt is used here for most biomes.
Avoid using complex blocks such as:
If you use such blocks, the worldgen will be slow and the loaded world may lag severely.
This parameter specifies a built-in noise preset that amplifies the terrain generation of the biome.
Values like beach and lowlands will generate more flat and even terrain lower on the ground, while
mountains and extreme will generate terrain higher up and more uneven.
This parameter controls the block that generates as part of the ocean or rivers.
Most vanilla biomes use water for this.
Avoid using complex blocks such as:
If you use such blocks, the worldgen will be slow and the loaded world may lag severely.
This parameter determines how densely packed the spawned particles will be in the biome.
This parameter controls how far below the world water level the sea floor should occur.
Most vanilla biomes have this value set to 7 by default.
This parameter determines the minimum and maximum snow level that can accumulate during snowfall.
Each multiple of 0.125 is another snow layer.
This parameter controls the block that generates below the middle block layer.
Most vanilla biomes use stone for this.
Avoid using complex blocks such as:
If you use such blocks, the worldgen will be slow and the loaded world may lag severely.
This parameter controls the block that generates under the water.
Most vanilla biomes use dirt or gravel block for this.
Avoid using complex blocks such as:
If you use such blocks, the worldgen will be slow and the loaded world may lag severely.
This parameter specifies which biome preset of the village structure will generate in your biome.